Haier HPRB07XC7 User Manual - Page 7

Assembly and Installation Accessories Include 1 2 3 1. Plastic panel - 2 pieces 2. Window Panel adapter - 1 piece 3. Screws - 4 pieces 4. Heat Exhaust hose connector - 2 pieces 5. Heat Exhaust hose - 1 piece 1. Push the round Window Panel Adapter through the rear of the Plastic Panel. A Line up the holes and tighten the Adapter with 4 screws that are included in the kit. (Tighten screws from the front.) 2. Adjust the Plastic Panel to the width or height of your window and tighten the 2 screws that are attached to the panel. 3. Install the Window Plastic Panel into the window. If necessary use duct tape to better secure the panel. 4. Connect exhaust hose to the unit by inserting the hose connector that is attached to the hose into the exhaust. (See Illustration A) 5. Move the unit to the window, extend the hose and attach the other end of B the hose to the window. Align the tabs on the hose and window panel adapters and fasten them together. 6. Plug into wall outlet to get ready for operation. * NOTE: Use on Single Outlet Circuit Only. 4 Hose Connector 5 Exhaust Hose 4 Hose Connector English 6