Haier HPU-16CB03 User Manual - Page 25

Tools necessary Tools necessary 1. Screw driver 2. Hacksaw 3. 70mm dia. hole core drill 4. Spanner (dia. 17, 27mm) 5. Spanner (14, 17, 19, 27mm) 6. Pipe cutter 7. Flaring tool 8. Knife 9. Nipper 10. Gas leakage detector or soap water 11. Measuring tape 12. Reamer Standard accessories Parts in the following list are accessories for the unit installation which can be used if necessary. No. Shape and description QTY HEALTH 1 RESET LIGHT CLOCK TIMER SLEEP SET MODE FAN SWING TEMP ONOFF 1 LOCK Remote controller 2 Cement nail 3 3 Connect pipe 4 Drain hose 1 5 Heat-insalution pipe 2 6 L-shaped metal 2 7 Fall-prevention fitting metal 1 Following parts shall be field supplied 8 Mark Parts name A Adhesive tape 9 B Pipe clip C Connecting hose 10 D Insulation material 11 E Putty F Drain hose 12 Wire clip 4 Drain elbow 1 Self-tapping scerw 3 Rubber pad 4 Connect unit wire 1 Remarks: (1) For side panel air inlet grille and air filter, model 16 has 1, model 23 has 2. (2) a: For model 16, the side panel air inlet grille and air filter are installed on the premade rounded hole of either right or left side panel; b: For model 23, when the premade rounded hole of right/left side panel is not occupied by connecting pipe, the two holes shall be installed with side panel air inlet grille and air filter; if one of the premade holes is occupied by connecting pipe, the side panel air inlet grille and air filter shall be installed in the nonoccupied rounded hole and the premade hole of rear protection panel. 23 13 Adhesive tape 1 14 Wall hole cover 1 15 Piping hole cover 1 16 Dry battery 7# 2 17 Ventilation pipe (3 long and 1 short) 4 18 Joint of ventilation pipe 2 Protection cover of ventilation pipe 19 (2 large and 1 small) 3 20 Side panel air inlet grille 1 21 Side panel air filter 1 For cooling only type.drain elbow is not available