Haier HPU-24C03 User Manual - Page 12

Operation DRY Operation Control panel Remote Controller  E.HEAT 1.Unit start Press ON/OFF button on the indoor unit or press ON/OFF on the remote controller, unit starts. The liquid crystal will display the working state of last time (Expcept Timer, Sleep ). 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: Remote controller: $ 8 72 &22/ ' 5 < +( $ 7 )$1 Control panel: $ 8 72 &22/ ' 5 < +( $ 7 )$1 Then Select DRY operation. 3.Select temp.setting Press TEMP. button. Every time the button is pressed, temp. setting increases 1°C , if kept depressed, it will increase rapidly. Every time the button is pressed, temp. setting decreases 1°C , if kept depressed, it will decrease rapidly. 4. Fan speed selection Press FAN button. For each press, fan speed changes as follows: Remote controller: COOL operation starts when room temp. is higher than temp. setting. Ultra-low air flow Temp. setting+2 C Temp. setting On reaching temp. setting +2°C, unit will run in mild DRY mode. Air conditioner is running under displayed wind speed. In DRY mode: (1)When room temperature becomes 2°C higher than temp. setting, unit will run at setting at Temp.. speed regardless of FAN setting; (2)When room temperature becomes between temp. setting and temp.setting+2°C, unit will run at setting at LO; (3) When room temperature becomes lower than temp. setting, unit will run spasmodically with 10 minutes ON and 6 minutes OFF . 5. Units top Press ON/OFF button, the unit stops. 11