Haier HPU-24C03 User Manual - Page 27
Electric wiring, Wiring of indoor unit, Wiring of outdoor unit
View all Haier HPU-24C03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installation Manual of Room Air Conditioner Note: When additional refrigerant is necessary, first purge air out of connecting pipe by external gas, then drive out the excessive rerigerant by purging method. Brand new unit is charged 80g more refrigerant than spec. This is only for first instaltion to purge air in the indoor unit and connecting pipe. When piping is longer than 5m, charge additional refrigerant specified in this list. ¶ Pipe length 5m 10m 15m ¶ Pipe length 5m 10m 15m Refrigerant charge(g) 100 200 Refrigerant charge(g) 300 600 Electric wiring Note: Electric wiring must be done by qualified person. Use copper wire only. The parameter of the connecting cable: HPU-18H03/E1: 3*2.5+2*0.75 HPU-18C03/E1˖3*2.5 HPU-24H03/E1˖3*2.5+3*0.75 HPU-24C03/E1 ˖ 4*0.75 Wiring of indoor unit Insert the cable from outside the wall hole where piping already exist. Pull it out from front. Losen terminal screw and insert cable end fully into terminal block, then tighten it Pull the cable gently to make sure it is tight. 1(L) Replace cover after wiring. Indoor unit -/ /- Indoor unit Indoor unit Indoor Indoor unit Outdoor unit +38&( Outdoor unit +38&( Outdoor / 1 Outdoor unit +38+( Outdoor unit +38+( Note: User should prepare the part in the dashed Wiring of outdoor unit frame by himself. Insert the cable from inside the wall hole where piping already exist. Pull it out from front. Loose terminal screw and insert cable end fully into terminal block, then tighten it Pull the cable gently to make sure it is tight. Replace cover after wiring. Note: When connecting indoor and outdoor wire, check the number on indoor and outdoor terminal blocks. Terminals of same number and same color shall be connected by the same wire. Incorrect wiring may damage air conditioner's control or cause operation failure. 26