Haier HPU-42H03 User Manual - Page 7

Operation

Page 7 highlights

Operation Clock set When unit is started for the first time and after replacing batteries in remote TIMER TIME 2 CLOCK TIME 1 SET SLEEP 3 : AM controller, clock should be adjusted as follows: Press CLOCK button, "AM"or "PM" flashes. Press or to set correct time. Each press will increase or decrease 1 min . If the button is kept depressed, time will change quickly. After time setting is confirmed, press SET, "AM" and "PM" stop flashing, while clock starts working. Remote controller's operation TEMP TEMP MODE SWING FANSPEED ON OFF AM TEMP ON SWING OFF FAN When in use, put the signal transmission head directly to the receiver hole on the indoor unit The distance between the signal transmission head and the receiver hole should be within 7m without any obsacles as well. Don't throw the controller, prevent it from being damaged. When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wireless telephone is installed in the room, the receiver is apt to be disturbed in receiving the signal so the distance to the indoor unit should be shorter. reset key MODE CLOCK TIMER SLEEP SET LOCK RESET Loading of the battery Slinghtly press " " and push down the cover. Load the batteries as illustrated. 2 R-03 dry batteries, (cylinder) Be sure that the loading is in line with the "+"/"-" pole request as illustrated. Put on the cover again Confirmation indicator: In disorderation, reload the batteries or load the new batteries after 5 mins. Note:The waster batteries should be disposed properly,use two new same-type batteries when loading. If the remote controller canít function normally or doesnít work at all,use a sharp-pointed item to pres the reset key. Hint:Remove the batteries in case unit wonít be in usaged for a long period. If there are any displays after taking-out just need to press reset key. THE MACHINE IS ADAPTIVE IN FOLLOWING SITUATION Applicable ambient temperature range: Cooling Heating Indoor Outdoor Indoor Outdoor Maximum: D.B/W.B Minimum: D.B/W.B Maximum: D.B/W.B Minimum: D.B Maximum: D.B Minimum: D.B Maximum: D.B/W.B Minimum: D.B/W.B 32 C/23 C 18 C/14 C 43 C/26 C 18 C 27 C 15 C 24 C/18 C -7 C/-8 C 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33

Operation
5
Clock set
When unit is started for the first time
and after replacing batteries in remote
controller, clock should be adjusted as follows:
Press CLOCK button, "AM"or "PM" flashes.
Press
or
to set correct time. Each press will increase
or decrease 1 min . If the button is kept depressed, time
will change quickly.
After time setting is confirmed, press SET, "AM" and "PM"
stop flashing, while clock starts working.
Remote controller's operation
When in use, put the signal transmission head directly to the
receiver hole on the indoor unit
The distance between the signal transmission head and the
receiver hole should be within 7m without any obsacles as well.
Don't throw the controller, prevent it from being damaged.
When electronic-started type fluorescent lamp or change-over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to be disturbed in receiving the signal
so the distance to the indoor unit should be shorter.
Loading of the battery
Slinghtly press "
" and push down the cover.
Load the batteries as illustrated.
2 R-03 dry batteries, (cylinder)
Be sure that the loading is in line with the "+"/"-" pole
request as illustrated.
Put
on
the
cover
again
Confirmation
indicator:
In disorderation, reload the batteries or load the new batteries after 5 mins.
reset key
AM
TEMP
SWING
FAN
ON
OFF
MODE
SLEEP
SET
CLOCK
TIMER
RESET
LOCK
AM
TIMER
CLOCK
SET
TIME
TIME
SLEEP
TEMP
TEMP
SWING
MODE
FAN SPEED
ON
OFF
:
1
3
2
THE MACHINE IS ADAPTIVE IN FOLLOWING SITUATION
Applicable ambient temperature range:
Cooling
Heating
Indoor
Outdoor
Indoor
Outdoor
Maximum: D.B/W.B
Minimum:
D.B/W.B
Maximum: D.B/W.B
Minimum:
D.B
Maximum: D.B
Minimum:
D.B
Maximum: D.B/W.B
Minimum:
D.B/W.B
32 C/23 C
18 C/14 C
18 C
43 C/26 C
27 C
15 C
24 C/18 C
-7 C/-8 C
Note:The waster batteries should be disposed properly,use two new same-type batteries when loading.
If the remote controller canít function normally or doesnít work at all,use a sharp-pointed item to pres
the reset key.
Hint:Remove the batteries in case unit wonít be in usaged for a long period.
If there are any displays after taking-out just need to press reset key.