Haier HSU18XH7-G Service Manual - Page 26
Parts and Functions
View all Haier HSU18XH7-G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
HSU-18 24HEK13/R2 Parts and Functions System Configuration Indoor Unit Remote controller 1 2 3 45 6 5 87 1 Inlet 2 Inlet grille 3 Air Purifying Filter (inside) 54 Outlet 45 Horizontal flap (adjust up and down air flow Don't adjust it manually) 6 Vertical blade (adjust left and right air flow) Actual inlet grille may vary from the one shown in the manual according to the product purchased 7 Display board 1 2 3 4 5 1 Signal receiver hole 2 ON/OFF display 3 Ambient temp.display When receiving the remote control signal, display the set temperature and in the rest time the room temperature is displayed and this room temperature is only for reference. Outdoor Unit 4 TIMER ON\OFF display TIMER ON-OFF display SLEEP display Note to the power failure resume: press the sleep button ten times in five seconds and enter function after hearing four sounds.And press the sleep button ten times within five seconds and leave this function after hearing two sounds. 5 COOL\HEAT\Dry\AUTO display 16 17 14 18 13 12 19 11 20 21 22 23 24 25 26 28 2 29 30 1.CODE Used to select CODE A or B which will be displayed on LCD.Please select A without special explanation. 2.LIGHT button Control the lightening and extinguishing of the indoor LED display board. 3. TIMER button 4. CLOCK button 5. SLEEP button 7. HOUR button 8. MODE button 9. ON/OFF button 10. TIMER ON display 11. FAN SPEED display LOW MED HI AUTO 12. LOCK display 13. SWING display 14. SLEEP display 16. Operation mode display Operation mode AUTO COOL DRY FAN HEAT Remote controller 17.Signal sending display 18. POWER/SOFT display 19. TEMP display 20.TIMER OFF display 21. CLOCK display 22.TEMP button 23. FAN SPEED button 24.SWING button 25. . HEALTH AIRFLOW button 26. POWER/SOFT button 28. SET button 29. LOCK button If pressed, the other buttons will be disabled.Press it once again,lock will be cancelled. 30. RESET button When the remote controller appears abnormal,use a sharp pointed article to press this button to reset the remote controller normal. NOTE: Cooling only unit do not have displays and functions related with heating If the unit which you purchased has healthy function,follow it.If not,please ignore. Loading of the battery 1 Remove the battery cover; 2 2 Load the batteries as illustrated. 2 R-03 batteries, 1 resetting key(cylinder); OUTLET INLET CONNECTING PIPING AND ELECTRICAL WIRING 14 DRAIN HOSE Clock set Press CLOCK button, "AM" or "PM" flashes. Press or to set correct time. Each press will increase or decrease 1min. If the button is kept pressed,time will change quickly. After time setting is confirmed,press SET, "AM "and "PM" stop flashing,while clock starts working. 24 3 3Be sure that the loading is in line with the " + "/"-"; 4 Load the battery,then put on the cover again. Note: The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. When electronic-started type fluorescent lamp or change-over wireless telephone is installed in the type fluorescent lamp or room, the receiver is apt to be disturbed in receivingthe signals, so the distance to the indoor unit should be shorter. Full display or unclear display during operation indicates the batteries have been used up.Please change batteries. If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later. Hint: Remove the batteries in case unit won't be in usage for a long period. If there are any display after taking-out, just need to press reset key Domestic Air Conditioner