Haier HSU18XH7-G Service Manual - Page 45

HSU-18 24HEK13/R2 Installations 9. Installations Preparation Necessary Tools for Installation Selection of Installation Place Driver Nipper Hacksaw Hole core drill Spanner(17,19 and 26mm) Gas leakage detector or soap-and-water solution Torque wrench (17mm,22mm,26mm) Pipe cutter Flaring tool Knife Measuring tape Reamer Power Source Before inserting power plug into receptacle, check the voltage without fail. The power source is the same as the corresponding name plate. Install an exclusive branch circuit of the power. A receptacle shall be set up in a distance where the power cable can be reached. Do not extend the cable by cutting it. Indoor Unit Place, robust not causing vibration, where the body can be supported suf ciently. Place, not affected by heat or steam generated in the vicinity, where inlet and outlet of the unit are not disturbed. Place, possible to drain easily, where piping can be connected with the outdoor unit. Place, where cold air can be spread in a room entirely. Place, nearby a power receptacle, with enough space around. (Refer to drawings). Place where the distance of more than lm from televisions, radios, wireless apparatuses and uorescent lamps can be left. In the case of xing the remote controller on a wall, place where the indoor unit can receive signals when the uorescent lamps in the room are lightened. Outdoor Unit Place, which is less affected by rain or direct sunlight and is suf ciently ventilated. Place, possible to bear the unit, where vibration and noise are not increased. Place, where discharged wind and noise do not cause a nuisance to the neighbors. Place, where a distance marked is available as illustrated in the above gure. Drawing for the installation of indoor and outdoor units The models adopt HFC free refrigerant R410A more than 5cm Attention must be paid to the rising up of drain hose Accessory parts No. Accessory parts Number of articles 1 Remote controller 1 more than G 10cm Arrangement of piping directions Rear left Left Rear right Right Below more than 10cm A more than10cm more than 10cm The marks from A to G in the gure are the parts numbers. The distance between the indoor unit and the oor should be more than 2m. more than 60cm F C D E more than15cm Please be subject to the actual product purchased , the above picture is just for your reference. Read this manual before installation Explain suf ciently the operating means to the user according to this manual 2 R-03 dry battery 2 3 1 Mounting plate 4 1 Drain hose 5 4X50 Steel nail, cement 6 6 4X25 Screw Plastic cap 4 7 1 Drain-elbow 8 Cover 1 9 Cushion 4 10 1 Pipe supporting plate 11 Connecting cable 1 Note:Cooling only units don't have Drain-elbow Optional parts for piping A Non-adhesive tape B Adhesive tape C Saddle (L.S) with screws D Connecting electric cable for indoor and outdoor E Drain hose F Heating insulating material G Piping hole cover 43