Haier HSU18XH7-G Service Manual - Page 29

HSU-18 24HEK13/R2 System Configuration Operation Timer On/Off On-Off Operation Set clock correctly before starting TIMER operation. 1.After unit starts, select your desired operation mode. 2.Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: Remote controller: BLANK TIMER ON TIMER OFF TIMER ON-OFF Then select your desired TIMER mode (TIMER ON or TIMER OFF or TIMER ON-OFF). " "or " "will flash. 3.Press TIME+ /TIME- button to set time. It can be adjusted within 24 hours. 4.After setting correct time, press SET button to confirm " "or" " on the remote controller stops flashing. 5.Cancel TIMER mode Just press TIMER button several times until TIMER mode disappears. Hints: After replacing batteries or a power failure happens, time setting should be reset. Remote controller possesses memory function,when use TIMER mode next time, just press SET button after mode selecting if time setting is the same as previous one. According to the Time setting sequence of TIMER ON or TIMER OFF, either Start-Stop or Stop-Start can be achieved. Healthy airflow Operation 1.Press ON/OFF to starting Setting the comfort work conditions. 2.The setting of healthy airflow function 1).Press the button of healthy airflow, appears on the display. Horizontal airflow sending. Avoid the airflow blows direct to the body. 2).Press the button of healthy airflow again, appears on the display. Downward airflow sending. Avoid the airflow blows direct to the body. 3.The cancel of the healthy airflow function Press the button of healthy airflow again, the unit goes on working under the condition before the setting of healthy airflow function. Notice: Do not direct the flap by hand. Otherwise, the grille will run incorrectly. If the grille is not run correctly, stop for a minute and then start, adjusting by remote controller. Note: 1.After setting the healthy airflow function, the position grill is fixed. 2.In heating, it is better to select the mode. 3.In cooling, it is better to select the mode. 4.In cooling and dry, using the air conditioner for a long time under the high air humidity, condensate water may occur at the grille . 27 For Smart Use of The Air Conditioner Setting of proper room temperature Proper temperature Do not block the air inlet or outlet Close doors and win dows during operation During cooling operation prevent the penetration of direct sunlight with curtain or blind If the unit is not to be used for a long time, turn off the power supply main switch. OFF Use the lou vers effectively Use the timer effectively Remote Controller Indoor Body Do not use water wipe the controller with a dry cloth.Do not use glass cleaner or chemical cloth. Wipe the air conditioner by using a soft and dry cloth.For serious stains,use a neutral detergent diluted with water.Wring the water out of the cloth before wiping.then wipe off the detergent completely. Do not use the following for cleaning Gasoline,benzine, thinner or cleanser may damage the coating of the unit. Hot water over 40OC(104OF) may cause discoloring or deformation. Air Filter cleaning Open the inlet grille by pulling it upward. Remove the filter. Push up the filter's center tab slightly until it is released from the stopper, and remove the filter downward. Clean the filter. Use a vacuum cleaner to remove dust, or wash the filter with water.After washing, dry the filter completely in the shade. Attach the filter. Attach the filter correctly so that the "FRONT" indication is facing to the front.Make sure that the filter is completely fixed behind the stopper.If the right and left filters are not attached correctly, that may cause defects. Close the inlet grille. Once every two weeks Domestic Air Conditioner