Haier HWM33-200 User Manual - Page 16

Using process Procedure selection method Times of pushing the SELECT button Selected procedure Applicable circumstance Contents (the lighted indicators indicate the programs about to run) WASH, RINSE, SPIN WASH (the washing liquid remains in the tub) WASH - RINSE (the rinsing liquid remains in the tub) RINSE - SPIN When the common laundries need washing, rinsing and spinning. Repeat using the washing liquid When prevent the laundries from corrugating, and the laundries do not need spinning When the laundries need rinsing and spinning after manual washing WASH WASH WASH WASH RINSE SPIN RINSE SPIN RINSE SPIN RINSE SPIN Spin (spin after drain) When the laundries need only spinning after manual washing (first drain then spin) WASH RINSE SPIN Push the SELECT button for 5 times, and it will resume the initial mode. It will circulate in that sequence. 4.Switch the WATER LEVEL button to select suitable water level According to the capacity of the laundries, choose the three water levels High Middle Low After the water inlet as per the preset water level, in case additional water quantity is required, please first set the button to the Reset when the automatic inlet reaches the water level, you can turn to the needed water level. 5.Push the START/PAUSE button 5 Close the top lid. 6 The washing is finished. If you open the top lid, the machine will stop working before spinning. It beeps to indicate the finishing of washing The power will be switched off automatically after the finishing of the washing.