Haier HWM33-200 User Manual - Page 18
Trouble-shootingAnswers to questions
View all Haier HWM33-200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Trouble-shootingAnswers to questions (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomenon Reason How to solve The wash, rinse spin and gentle s lamps are flashing. The machine does not spin. The top lid is opened. Close the top lid. The wash, rinse, spin and jeans s lamps are flashing. Is the drain hose blocked? The drainage cannot work, or is too slow. The safety switch acts, and the spinning cannot work. The wash, spin, jeans and speedy s lamps are flashing. Are the laundries put slantingly? Is the machine slanting? Clean the foreign material. Push the start button again. Reorder the laundries. Close the top lid. Set the washing machine horizontally and then open and close the top lid once. The machine does not act. Not wash Not spin There's abnormal sound inside the machine The water faucet leaks water No water inlet. Is there power failure? Is the power plug inserted tightly? Is the water level reached preset position? Please use it when there's power supply. Insert the power plug tightly. Fill water to the preset position. Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? Is the machine slanting? Are there any foreign materials? Are the laundries put slantingly in spinning? Insert the power plug tightly. Close the top lid. Set the laundries flat. Adjust the machine to be even Remove the foreign materials. Reorder the laundries and close the top lid. Is the screw of the water inlet hose jointer loose? Is the screw of the water inlet hose jointer twisted awry? Is the power plug plugged tightly? Is the water faucet opened? Are the POWER ON/OFF and START/PAUSE buttons pushed down? Fasten the screw of the jointer properly. Plug the power plug tightly. Open the water faucet. Push the power ON/OFF button and START/PAUSE button. Common phenomena Phenomena The spinning is intermittent when it starts. Push the SPIN button, but it doesn't act. There may be some water flowing out of the drain hose in the first use of the machine. The pulsator pauses during water filling in washing and rinsing. Explanation It is to balance the laundries to avoid slanting. The program is setting the drain time. A certain period is needed before it starts spinning. It is the water remained in the machine during the ex-factory performance inspection. It is to avoid splashing during water filling.