Haier HWM60-20B User Manual - Page 17
Trouble-shooting, Answer to question
View all Haier HWM60-20B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena The reason How to settle The digitron displays E0. The drainage cannot work, or is too slow. The digitron displays E1. Running pauses during spin, nixie tube indicates "E2", buzzing The top lid is opened during reserve procedure. Is the drain hose put down? Is the drain hose blocked? The top lid is not closed. Close the top lid. Put down the drain hose. Open and close the top lid once. Clean the foreign material. Open and close The top Lid Once. Close the top lid. The safety switch acts, and the spinning cannot work. The digitron displays E3. The water filling does not work, or is slow. After about 40 minutes later, the digital displays E4. The digitron displays E6. The machine does not act Not wash Not spin There's abnormal sound inside the machine The water tap leaks Common phenomena Are the laundries put slantingly? Is the machine slanting? Is the water tap opened, or is there water supply failure? Is the water inlet valve blocked? Is the water pressure too low? The water level sensor is bad. Is there power failure? Is the power plug inserted tightly? Is the water level reached preset position? Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? Is the machine slanting? Are the laundries put slantingly in spinning? Are there any foreign materials? Is the screw of the jointer of water inlet hose loose or awry? Reorder the laundries. Close the top lid. Set the washing machine horizontally and then open and close the top lid once. Open the water tap. Open and close the top lid once. Clean the water inlet valve then open and close the top lid once. Open and close the top lid once. Please contact the after-sales service department. Please use it when there's power supply. Insert the power plug tightly. Fill water to the preset position. Insert the power plug tightly. Close the top lid. Set the laundries flat. Adjust the machine to be even Reorder the laundries and close the top lid. Remove the foreign materials. Fasten the screw of the jointer properly. Phenomena Explanation The spinning is intermittent when it starts. The wash procedure pauses. Select spin program, but it does not work. The pulsator pauses during water filling in washing and rinsing. There may be some water flowing out of the drain hose in the first use of the machine. When the power plug is inserted, computer board indicator is switched on, and the machine starts working Balance the laundries to avoid slanting. The cloth sensor is detecting , it will add water after about 48 senconds The program is setting the drain time , certain period is needed before it starts spinning. It is to avoid splashing during water filling. It is the water remained performance inspection by the factory. It is the special resume function. In the case of power failure or the power plug is loose during washing, the machine can save the running program, and resume the program after the power supply is recovered. You do not need to set the program again 15