Haier HWM65-187S User Manual - Page 10

Dismantling and installation of the base frame

Get Haier HWM65-187S PDF manuals and user guides View all Haier HWM65-187S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

INSTALLATION AND ACCESSORY PARTS Dismantling and installation of the base frame Dismantle the back cover. Loosen the wires. Loosen the fastening screw of the spin tub shaft. Separate the shaft from the brake wheel. Loosen the brake hook. Take off the brake cable frame from the installation groove of the twin-tub. Take off the V-belt. Take out the drain hose from the groove of the base frame. Loosen the fastening screw between the base frame and the cabinet to dismantle the base frame component. Dismantling and installation of the bearing seat Once the bearing seat is taken off, it can not be utilized again. Therefore do not dismantle it as far as possible. In case that it has to be replaced, please dismantle it as per following sequence, then install a new bearing seat. Dismantle the spin tub . Then pull out the bearing seat. Cut off the inner lining claw inside the bearing seat with cutting pliers and take it out. Install the new bearing seat and inner lining. Right Wrong Figure 9 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
Dismantling and installation of the base frame
Dismantle
the
back cover. Loosen the wires. Loosen the
fastening screw of
the spin tub shaft. Separate
the shaft
from
the brake wheel.
Loosen
the
brake hook. Take off
the brake
cable frame from the
installation groove of the
twin-tub. Take off the V-belt. Take out the drain hose from
the groove of the base frame. Loosen the fastening screw
between the base frame and
the cabinet to dismantle the
base frame component.
Dismantling and installation of the bearing seat
Once
the bearing seat
is
taken off,
it can not be utilized again. Therefore
do
not
dismantle
it
as far as possible.
In
case that
it has
to
be replaced, please dismantle it as
per following
sequence, then install a new bearing seat.
Dismantle the spin tub . Then pull out the bearing seat.
Cut off the inner lining claw inside the bearing seat with cutting pliers and
take it out.
Install the new bearing seat and inner lining.
Dismantling and installation of the bearing seat
Once
the bearing seat
is
taken off,
it can not be utilized again. Therefore
do
not
dismantle
it
as far as possible.
In
case that
it has
to
be replaced, please dismantle it as
per following
sequence, then install a new bearing seat.
Dismantle the spin tub . Then pull out the bearing seat.
Cut off the inner lining claw inside the bearing seat with cutting pliers and
take it out.
Install the new bearing seat and inner lining.
Figure 9
Right
Wrong
9
INSTALLATION AND ACCESSORY PARTS