Haier HWM65-187S User Manual - Page 9
Points of Attention in After-sales Service
View all Haier HWM65-187S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
INSTALLATION AND ACCESSORY PARTS Points of Attention in After-sales Service Be sure to switch off the power during dismantling or repair. Be sure to use insulated wiring terminals and insulation box in connection of the wires, and crimp and fix to proper position with suitable tools. In welding connections with electric iron, be sure to twist the wires before welding, and insulate with insulation tapes. In welding the wires with electric iron, be sure not to touch the resin part and insulation part of each switch. The inlay connection wires and terminals shall not be loose or drop. Do not make the wires touch the moving parts like the belt, pulley of the motor, brake bar etc. Do not make the wires touch the sharp edges and high-temperature area. In case that there are metal parts with the wires, do not make the wires touch the metal parts. Insulation materials are needed between them. After assembly, the washing machine shall act normally. Check if it leaks and if the sound and vibration are normal. Dismantling and installation of the control panel component Loosen the fastening screws. Pull towards the direction indicated in the figure to dismantle the control panel. In installation the beard shall lock into the installation hole of the major frame. (Figure 6) Dismantling and installation of the spin tub Figure 6 frame component Push the points marked with " " as indicated in the figure and pull the spin tub frame towards upper left direction to dismantle the spin tub frame components. In installation, after set the rear side of the spin tub frame to proper position, push the four points marked with " " downwards by force to resume its original position. (Figure 7) Dismantle Installation Spin tub frame Figure 7 Spin tub shaft Bearing seat Dismantling and installation of the spin tub Dismantle the spin tub frame component. Loosen the fastening screw of the spin tub shaft. The spin tub then can be taken out. In installation, be sure to inlay the bulge of the inner lining of the brake wheel into the groove of the spin tub shaft. (Figure 8 Oilite bearing Inner lining of the bearing seat Fastening screw Inner lining of the brake wheel Fastening screw of the brake wheel Brake wheel Spin motor shaft Figure 8 8