Haier HWM65-828 User Manual - Page 5

Before washing, please fold up the laundry as needed, then put the laundry into the inner tub, flat and neat. These fabrics are not washable: 1.Fabrics that deform when soaked in water; 2.Fabrics that shrink, discolor or go through other exterior changes when soaked in water; 3.Fabrics that lose original texture when soaked in water; 4.Fabrics that discolor when soaked in water; 5.Fabrics that have pilling or pressed pile when soaked in water; 6.Fabrics that is damageable when soaked in water. Upon completion of washing, iron the laundry with a steam iron. Hold the steam iron above the laundry and do not touch the laundry. Reshape the laundry. (As illustrated in Fig 1) Figure 1 When shrinkage occurs Stretch the laundry to its original size and locate it with pins. Use a steam iron to dry the laundry completely. Do not touch the laundry. (As illustrated in Fig 2) Pin Figure 2 3 Push "SOAK" "WASH" "RINSE" "SPIN" button to select suitable procedure program Even there's no water in the tub, a certain period is required before spin starting. Separate the laundries that are not colorfast from other laundries in washing. The soak procedure can work in cooperation with automatic programs like STANDARD, HEAVY, CHILD, MEMORY GENTLE. There is intermittent pulsator stirring during soak. After the machine starts operation, you can only set the program and procedure during washing and soaking, During rinsing ,you can only set the spinning time, and can not make setting in other cases. During SPEEDY, TUB DRY programs, push the WASH, RINSE,SPIN button the machine has no reaction. 4 Push the " WATER LEVEL "button, select suitable water level For STANDARD program, the washing machine will execute fuzzy program automatically to detect the cloth. After defection, it can set the water level automatically.To select other water level, first push the "START/PAUSE" button, then push the "WATER LEVEL" button to set the water level. 5 Push the "DELAY" button to select suitable reserve wash program After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing procedure to be finished at reserved time, please push the DELAY "+ - " button to set the reserve wash program. Refer to reserve button in Page 13 for selection. When the DELAY function is activated, the indicator light of the program you have set will be off. The digitron will display remaining delay time(hour). During reserve procedure, push the "DELAY"+ - " button to display the reserve mode. To change the running program or cancel the reserve setting, you need to switch off the power and make new selection. 6 Push the "START/PAUSE" button Close the top lid As the top lid opened, the washer will automatically alarm and stop running, exclusively during draining and water filling. Finish washing After finishing washing ,it'll alarm and switch off power automatically. Safety precautions Do not put hand into the rotating tub. It is dangerous even if the rotation speed is slow. Take special care of the children. Keep children away from the washing machine to avoid them climbing on. Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items (such as the kettle with hot water) on the washing machine. Do not wash laundries with volatile materials (such as thinner, petrol etc.). Petrol Benzene This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Keep the machine away from direct sunlight and heat source like the heater. Please keep the lint filter in good condition, and install it to proper position during washing. If the lint filter is lost or Install damaged, please contact the customer care agent of our company. Dismantle To protect your laundries and washing machine, please take out all of the coins, buttons, sand, hairpin and other foreign materials before washing. Please check if the water faucet is open, and if the connection of the water inlet pipe is proper. It is suggested to use foamless washing powder. To change the direction of drain pipe, please contact the customer care agent of our company. Please don t use the washer in the environment below 0 C; if the washer has been stored below 0 C, please be sure to ensure the washer is placed under the room temperature for 2~4 hours and then use otherwise the washing effects may be lowered or the washer may be damaged.