Haier HWM70-918NZP User Manual - Page 11

Use the operation buttons Off On: indicate the program about to run,or indicate the selected mode or indicate the water level Flashing: indicate the running program During sensing, it displays "--" . During delay procedure, it displays the remained delay time (in hours). During operation of programs,it displays the remaining time (in minutes). In case of abnormal phenomenon, it displays the abnormal symbols (see to Page 15 ). Push the "Power" button to switch on the power. When the power is on, push it again to switch off the power. Push the "Power" button to switch on the power.If the "Start/Pause" button is not pushed, the washing machine will automatically switch off the power after 5 minutes. After the power is switched on,press it to start the machine. During working, push it to pause. During pause, push this button to restart and go on working . Memory Standard Wool Tub Dry Normal Strong Soft Quick Overflow Remaining Time Delay Time 47L 38L 30L 22L 14L 52L 43L 1st Rinse 34L 2nd Rinse 26L 3rd Rinse 18L Power Program Wash Rinse Spin During Memory,Strong,Soft,Normal and Standard program you can adjust the value of them. For Wool you can select procedure , but can not change them. The digitron displays the time remained (in minutes) before the washing is finished. Push the "Delay" button, the digitron displaysthe delay time of washing (in hours).The indicator flashes to indicate that the delay function is operating. Push the "Delay" button to display the delay mode. Program Normal Strong Applicable situation Washing the normal laundries Washing the bigger and heavier laundries Soft Washing the woollen textiles or underwear Quick Memory Standard Wool Tub Dry Washing the laundries with small quantity and light soil The common wash, the washer will set to Custom program including wash, rinse, spin and water level automatically last time Washing the normal laundries with less water Washing the woollen textiles Drying the inner tub and the outer tub, which can avoid growing mildew Delay Water level Reserve Water Start/Pause You can choose "Reserve Water" to keep water. It will keep the after rinsing water once finish rinsing in tub about 4 hours ,and buzzer every 15 minutes . Press "Start/Pause" button or open and close the top one time to collect the after rinsing water ,or else it will drain automatically,then go on for next program . The washing machine can detect the laundries automatically after detection, it will set the water level to suitable value among level 26L,34L,43L, 52L automatically during the Normal,Memory and Standard program. You can also set water level by yourself.After the machine is started, it will not set water level automatically. You shall push the "Start/Pause" button to make new setting. If there's water inside the tub, the machine can not detect the laundries and will display water level 34L .If wet laundries are put in, it may display water level 52L.You must set suitable water level by yourself. If Quick program is selected, it will display water level 22L, the water level can be adjusted. If Tub Dry program is selected, the water level will not respond. During operation of wash , rinse and soak program, you can push down the water level button to add water. When you release the button, or it reaches the overflow water level, the machine will stop adding water. The water level decided may be different from actual value because of the different moisture level of the laundries. 11