Haier HWM70-918NZP User Manual - Page 14

Cleaning the lint filter: 1 Push down the spring piece at the top of the lint filter to make the claws out of the filter cover, and then pull out the lint filter to get it down.(figure 1) 2 Pull the back cover of the lint filter, and then you can get down it off the front cover of the lint filter.(figure 2) Sweep the rubbish in the lint filter.Put the back cover of the lint filter into the front cover . 3 Put the lint filter into filter cover, and make it tight . 4 Make sure the lint filter well installed, or it can influence your use. Filter cover Lint filter A Figure 1 Figure 2 The lint filter must be used during washing. It must be cleaned in time after each using. Notes:  The filter screen of the water inlet valve is likely to be blocked by foreign materials and influence the water inlet. Please clean it with brush every two months.  If the cabinet is dirty, wipe it with wet cloth  Do not flush it directly with water.  Wipe it with neutral detergent.  Do not wipe it with thinner, petrol, alcohol etc.  After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).  Do not store water in the washing machine for a long period. Drain the water completely after each using.  Be sure to pull off the power plug before maintenance.  Hang up the power cord and drain hose.  Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid for some time ( about 1 hour), then close the top lid. 14