Haier HWM80-0566 User Manual - Page 8

Install the water inlet hose Confirm the water faucet Water faucet,suitable Outlet end surface Water faucet,not suitable >10mm It is required that the front end shall be longer than 10mm. The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage. Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. 2. Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water. See to Figure 3.) water inlet hose jointer Slider Screw Lock level Screw knife Sign plate Bushing water inlet hose Figure 1 Figure 2 Figure 3 3.Fasten the four screws evenly. See to Figure 4. 4 Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the exit end face of the faucet. See to Figure 5. remark: Before installation, the threading is 4mmabove the upper surface of the nut. After installation, the threading is 2mm above the upper surface of the nut. See to figure 6. About 4mm before twisting About less than 2mm after twisting Figure 4 Screw nut Figure 5 Figure 6 "Start/pause" button After the power is switched on, press it to start the machine During working, push it to pause. During pause, push this button to restart and go on working "Power" button Push the "power" button to switch on the power. Under power-on mode, push it to switch off the power. Push the "power" button to switch on the power. If the "start/pause" button is not pushed, the machine will switch off the power automatically after 5 minutes. STANDARD BLANKET SAVE SILK COTTON 1HOUR 2HOUR PROGRAM AIR DRY SPTAAURSTE POONW/EORFF "Program" button Following full-auto program is available Program Application Standard Common washing Blanket Washing for coverlet, bigger ,heavy thickness laundries Save Washing for the normal laundries Silk Washing for silk textiles Cotton Tub dry Washing for cotton textiles Avoid growing mildew on the outer tub and the inner tub "AIR-DRY"button Push the "AIR-DRY" button ,then the"AIR-DRY" indicator light is on, that means the "AIR-DRY" program is chosen. The purpose isdrying the inner tub and the outer tub, which can avoid growing mildew on the outer tub and the inner tub.