Haier HWS60-50 User Manual - Page 7
Spin process
View all Haier HWS60-50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Spin process 1 Put the laundries in properly 2 Put the gland in properly 3 Close the inner and outer cover of the spin tub 4 Do you need water-added Rinsing-spinnning Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt, It works in a way as follows: Spin Spin for about 1~2 minutes Remove most of the foam extra detergent liquid. Foam-removing spinning Fill water for Spin for about about 1 minutes 1~2 minutes Remove the detergent liquid remained Note: If there needs no water-added rinsing-spinning , set the duration for spinning directly. The effect is best when the laundries quantity is below 80% of the rated value. 5 Take the laundry out when the spinning ends. When the spinning ends, open the top lid and the interior lid. Then take out the depression cover and laundry after the spinning drum has stopped rotation completely. Note: Refer to the Notes on Spinning carefully. If you need water-added rinsing-spinning between the water hose and filling inlet. Install the water inlet hose , please check the connection Water inlet hose The water hose should be connected as shown in the right figure. Water inlet entrance Notes on Spinning Use the foam-removing spinning to remove the extra detergent liquid. It can both shorten the washing time and save the water consumption. Please put in the gland properly even if the laundries quantity is small. .Do not leave any articles above the depression cover. Push Gland Push Proper The laundries are slanting Proper No gland