Haier PDVD770 User Manual - Page 10

4. VIDEO SETUP VIDEO SETUP BRIGHTNESS CONTRAST HUE SATURATION EXIT SETUP 4.1 BRIGHTNESS-- to set the brightness for the display. Options: 0/2/4/6/8/10/12 4.2 CONTRAST--to set the contrast effect for display. Options: 0/2/4/6/8/10/12 4.3 HUE--to set the colour impression for display. Options: -6/-4/-2/0/+2/+4/+6 4.4 SATURATION--to set the saturation level for display. Options: 0/2/4/6/8/10/12 5. SPEAKER SETUP SPEAKER SETUP DOWNMIX EXIT SETUP DISC HANDLING PRECAUTIONS — Hold the disc by the edge so the surface will not be soiled with finger prints. Finger prints, dirt and scratches can cause skipping and distortion. — Do not write on the label side with a ball-point pen or other writing utensils. — Do not apply benzine, thinner, and liquid that prevents against static electricity. — Be careful not to drop or bend the disc. — Instal only one disc on the disc tray. — Do not try to close the disc tray when the disc is not in stalled properly. — Be sure to store the disc in it's case when not in use. 5.1 DOWNMIX Options: LT/RT- Left/Right mix mode STEREO- Select this option if you don't have a 5.1 channels amplifier. TROUBLESHOOTING If your DVD player does not seem to be functioning properly, check the items below before you contact an authorized service center Symptom Check Power does not turn on or suddenly turns off. Battery pack is in place but the power does not turn on or suddenly turns off Make sure the AC adapter is securely plugged into an AC outlet. Turn the power off and then back on. Check that the battery pack is charged. If not, recharge it. Remote control won't work No picture or sound No picture No sound No picture and sound Distorted video or sound Check that the battery is inserted in the and direction properly. The battery may be flat. Replace it with a new one. Check that the signal transmission is directed at the remote control sensor on the DVD player. Remove the obstacle between the remote controller and remote control sensor. Check that the A/V cables are securely connected. Check that the disc is a DVD (region number 1 or all), DVD-RW, VIDEO CD or AUDIO CD. Do not use a disc that has scratches or dirt. Check that the label-side of the disc is facing up. The pick-up lens of the DVD player may be dirty. Contact the service center for lens cleaning. Check that the TV channel is set to VIDEO or AV if viewing with a TV. Check that the LCD display is turned on. Check that the display panel is open. If it is closed, audio will not be output to the speakers. Check the volume setting. If set to zero, turn up volume level. Check that the headphones are plugged into the PHONES socket. Speakers cannot be used with the headphones. Check that the battery is properly installed and AC Adapter is properly connected. Use a disc without scratches or dents. 9