Haier QAS740RMSS Installation Instructions - Page 4
Final Installation Checklist, Operation Checklist, Level The Range, Install And Check, Anti-tip
![]() |
View all Haier QAS740RMSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
6 LEVEL THE RANGE WARNING Never completely remove the leveling leg as the range will not be secured to the anti-tip device properly. A. Plug in the unit. B. Measure the height of your countertop at the rear of the opening (X). C. Adjust two rear leveling legs so that the rear of cooktop is at the same height or higher than the counter (Y). D. Slide unit into place. E. Install oven shelves in the oven and position the range where it will be installed. F. Check for levelness by placing a spirit level on one of the oven shelves. Take two readings-with the level placed diagonally first in one direction and then the other. G. Adjust front leveling legs until the range is level. X Y Spirit level 7 INSTALL AND CHECK ANTI-TIP DEVICE WARNING Never completely remove the leveling leg as the range will not engage anti-tip device properly. To reduce the risk of tipping the range, the range must be secured by a properly installed anti tip bracket. Follow instructions supplied with ANTI-TIP bracket. Anti-Tip Bracket Kit Included 8 FINAL INSTALLATION CHECKLIST • Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced. • Be sure power is in service to the building. • Check that all packing materials and tape have been removed. This will include tape on metal panel under control knobs (if applicable), adhesive tape, wire ties, cardboard and protective plastic. Failure to remove these materials could result in damage to the appliance once the appliance has been turned on and surfaces have heated. • Check that the door and drawer are parallel to each other and that both operate smoothly. If they do not, see the Owner's Manual for proper replacement. • Check to make sure the anti tip bracket is installed. Verify the anti tip bracket is working correctly. Grasp the back of the range, being careful not to grab or bend the rear trim piece. Tilt the range forward slightly and confirm the anti tip bracket engages the back of the range. If the anti tip is not present or it is not engaging the range correctly, call 1-800-626-8774 in the US or 1-800-561-3344 in Canada. • Check to make sure the two rear wall spacers are installed on the back of the range. OPERATION CHECKLIST • Check that the oven control operates properly. If the oven control does not operate properly, recheck the wiring connections. • Be sure all range controls are in the OFF position before leaving the range. INSTALLATION INSTRUCTION 31-11135 06-18 GEA QAS740, JAS640
![](/manual_guide/products/haier-qas740rmss-installation-instructions-744eb62/4.png)