Haier XQB50-18 User Manual - Page 18

Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomenan The reason How to settle The digitron displays E0. The top lid is opened during reserve procedure. Close the top lid. The drainage cannot work, or is too slow. The digitron displays E1. Is the drain hose put down? Is the drain hose blocked? Put down the drain hose. Open and close the top lid once. Clean the foreign material. Open and close The top Lid Once. It stops running in midway. The digitron displays E2. The top lid is not closed. Close the top lid. The safety switch acts, and the spinning cannot work. The digitron displays E3. Are the laundries put slantingly? Is the machine slanting? Reorder the laundries. Close the top lid. The machine will start running after 10 seconds of being placed horizontally. The water filling does not work, or is Is the water tap opened, or is there water slow. The digital displays E4. supply failure? Is the water inlet valve blocked? Is the water pressure too low? Open the water tap. Push the start/Pause button once. Clean the water inlet valve then push the start/Pausebutton once. Push the sStart/Pause button once. The digitron displays E6. The water level sensor is bad. Please contact the after-sales service department. The digitron displays E8. The digitron displays E9. The machine does not act Not wash Not spin The power voltage is too low. The power voltage is too high. Is there power failure? Is the power plug inserted tightly? Is the water level reached preset position? Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? Pull off the power plug. Wait for the voltage resuming normal before usage. Please use it when there's power supply. Insert the power plug tightly. Fill water to the preset position. Insert the power plug tightly. Close the top lid. Set the laundries flat. There's abnormal sound inside the machine The water tap leaks Common phenomena Phenomena Is the machine slanting? Are the laundries put slantingly in spinning? Are there any foreign materials? Is the screw of the jointer of water inlet hose loose or awry? Adjust the machine to be even Reorder the laundries and close the top lid. Remove the foreign materials. Fasten the screw of the jointer properly. Explanation The spinning is intermittent when it starts. The wash procedure is pausing. Select SPIN program, but it doesn't work. The pulsator pauses during water inlet in wash and rinse. There may be some water flowing out of the drain hose in the first use of the machine. Balance the laundries to avoid slanting. The cloth sensor is checking the cloth. It will add water after about 48 seconds. The program is setting the drain time. Some time is needed before it starts spinning. It is to avoid splashing during water inlet. It is the water remained in the factory inspection of performance.