Harbor Freight Tools 69461 User Manual - Page 3

Setup Instructions

Get Harbor Freight Tools 69461 - Solar Copper LED Path Lights PDF manuals and user guides View all Harbor Freight Tools 69461 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

Setup Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual. Battery Setup There may be a paper tab in one end of the battery between the Battery (5) and the electrical contact so the Battery won't drain over time. To remove this: 1. Twist the Lamp Cover off the Lamp Housing. 2. Unthread the two screws on the battery cover and remove the battery cover. Caution: Be careful that the two wires holding the battery cover to the Lamp Housing are not pulled and disconnected. 3. Pull out the paper tab. 4. Replace the Battery cover and secure with the screws. 5. Replace the Lamp Cover onto the Lamp Housing. 6. Repeat steps 1 - 5 for the other lights. Functions Battery Cover (On Lamp Housing) and Battery (5) (Inside Lamp Housing) Power Switch (7) (On Battery Cover of Lamp Housing) Lamp Housing (1) Lamp Cover (2) Pole (3) Item 69461 Stake (4) Figure A For technical questions, please call 1-800-444-3353. Page 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
Page 3
For technical questions, please call 1-800-444-3353.
Item 69461
Setup Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Note:
For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram near the end of this manual.
Battery Setup
There may be a paper tab in one end of the battery between the Battery (5) and
the electrical contact so the Battery won’t drain over time. To remove this:
1.
Twist the Lamp Cover off the Lamp Housing.
2.
Unthread the two screws on the battery cover and remove the battery cover.
Caution:
Be careful that the two wires holding the battery cover
to the Lamp Housing are not pulled and disconnected.
3.
Pull out the paper tab.
4.
Replace the Battery cover and secure with the screws.
5.
Replace the Lamp Cover onto the Lamp Housing.
6.
Repeat steps 1 - 5 for the other lights.
Functions
Lamp Housing (1)
Lamp Cover (2)
Stake (4)
Pole (3)
Battery Cover
(On Lamp Housing)
and Battery (5)
(Inside Lamp Housing)
Power Switch (7)
(On Battery Cover
of Lamp Housing)
Figure A