Harbor Freight Tools 69461 User Manual - Page 5

Maintenance

Get Harbor Freight Tools 69461 - Solar Copper LED Path Lights PDF manuals and user guides View all Harbor Freight Tools 69461 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

Maintenance Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document including all text under subheadings therein before set up or use of this product. TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use. 1. Clean regularly with a damp towel. 4. Replace the batteries every 12 months. Do not use any type of solvent for cleaning. Do not put too much pressure on the Solar Panel or accessories a. Twist the Lamp Housing off the Lamp Cover. while cleaning. Dry thoroughly. b. Unthread the two screws 2. BEFORE EACH USE, inspect the general condition of the tool. Check for: on the battery cover and remove the battery cover. • leaking, swollen, or cracked battery, Caution: Be careful that the two wires holding the battery cover to the Lamp • loose hardware, Housing are not pulled and disconnected. • misalignment or binding of parts, c. Remove the old battery. • cracked or broken parts, and • any other condition that may affect its safe operation. 3. AFTER USE, wipe external surfaces of the tool with clean cloth. d. NiCd BATTERY MUST BE RECYCLED OR DISPOSED OF PROPERLY. Do not short, incinerate or open battery. e. Install a new NiCd AAA, 300mAh (or better) battery into the Battery Compartment. Check that the battery is placed according to the correct polarity. f. Replace the cover and secure in place with the Screws. g. Twist the Lamp Housing onto the Lamp Cover. Item 69461 For technical questions, please call 1-800-444-3353. Page 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
Page 5
For technical questions, please call 1-800-444-3353.
Item 69461
Maintenance
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem corrected before further use.
1.
Clean regularly with a damp towel.
Do not use any type of solvent for
cleaning.
Do not put too much pressure
on the Solar Panel or accessories
while cleaning.
Dry thoroughly.
2.
BEFORE EACH USE,
inspect the
general condition of the tool.
Check for:
•
leaking, swollen, or cracked battery,
•
loose hardware,
•
misalignment or binding of parts,
•
cracked or broken parts, and
•
any other condition that may
affect its safe operation.
3.
AFTER USE,
wipe external surfaces
of the tool with clean cloth.
4.
Replace the batteries every 12 months.
a. Twist the Lamp Housing
off the Lamp Cover.
b. Unthread the two screws
on the battery cover and
remove the battery cover.
Caution:
Be careful that the two wires
holding the battery cover to the Lamp
Housing are not pulled and disconnected.
c. Remove the old battery.
d. NiCd BATTERY MUST BE
RECYCLED OR DISPOSED OF
PROPERLY.
Do not short, incinerate
or open battery.
e. Install a new NiCd AAA,
300mAh (or better) battery
into the Battery Compartment.
Check that the battery is placed
according to the correct polarity.
f.
Replace the cover and secure
in place with the Screws.
g. Twist the Lamp Housing
onto the Lamp Cover.