Harman Kardon AVI200MKII Owners Manual - Page 16
Operation
View all Harman Kardon AVI200MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Operation AMPLIFIER SECTION 1. Set the VOLUME CONTROL to the extreme counterclockwise position. 2. Turn the power on. 3. Select the desired input function. 4. Play the input source. 5. Turn the VOLUME clockwise until you reach the desired sound level. TAPE RECORDING 1. Insert a blank tape in a cassette deck (TAPE1 or TAPE2). 2. Select the desired input function. 3. Set the cassette deck to recording mode. 4. Play the input source. Recording will start. TAPE DUBBING 1. Insert a blank tape in cassette deck 2 TAPE2). 2. Insert a recorded tape in cassette deck 1 (TAPE1). 3. Select the input function of TAPE2 MON to monitor the sound (see #9 on page 8). 4. Set cassette deck 2 to recording mode. 5. Set cassette deck 1 to playback mode. Dubbing will start. NOTE: If you press the TEST TONE button during TAPE RECORDING or TAPE DUBBING, the audio signal is not recorded. PROTECTION CIRCUITS This amplifier has special protection circuits. ■ The thermal overload protection circuit automatically turns off the power if it begins to overheat. ■ The overdrive protection circuit automatically turns off the power if it is about to deliver too much power. ■ The short protection circuit automatically turns off the power if the speaker terminals are shorted. If the amplifier shuts off, check to be sure that the ventilation holes on the top of the amplifier are clear of obstructions, and check the speaker connections and impedance. 15