Harman Kardon CIT25 Owners Manual - Page 17

Warranty and Service Sound from turntable contains hum. 1. Ground wire from turntable has not been connected to Citation 25's ground terminal. 2. Cable from turntable is too close to power cords or speaker cables. Sound only comes from one speaker while playing VCR. 1. VCR has a mono output. Press the MONO button on the Citation 25's flip-down panel. Sound lacks stereo image or sounds "lifeless". 1. MONO button has been left on while playing a stereo source. 2. HI CUT filter has been left on. When playing a record, sound is muddy. Acoustic feedback and "howling" occur. 1. Too much bass boost is being applied. Switch off LOUDNESS button, reduce the amount of BASS tone control boost, 2. Turntable is too close to speakers. 3. Turntable is placed on unstable surface. Remote does not function correctly. 1. Make sure the distance and operating angle do not exceed those described in this manual. 2. Check that the remote transmitter lens and front panel REMOTE SENSOR window arc clean. 3. Make sure that strong fluorescent lights are being used in your listening room. 4. Check that the batteries inside the remote arc fresh. If you have followed the suggestions in this manual and are reasonably sure that your preamplifier requires service, call the Harman Kardon dealer from which you purchased your Citation 25. It is important that service he carried out only by a designated Harman Kardon Service agent to insure both proper service and to comply with the terms of the Citation 25 Limited Warranty. Remember to keep your sales slip or receipt in a safe place since you will be required to show it for service during the duration of the Limited Warranty. Video Signal Path AN 1 (Video Input) AN 2 (Video Input) Function Selector I • VCR 1 (Video Input) VCR 2 (Video Input) ecord Out Switch Hound out Switch uCti/ Tape Monitor Switch Video Monitor Output VCR 1(Video Output) 4 VCR 2 (Video Output)