Harman Kardon CITATION 7.1 Owners Manual - Page 13
TATION, Channel, Operation, Three
View all Harman Kardon CITATION 7.1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
CI TATION Four-Channel Operation: Using high quality interconnect cables, connect one output of your processor to an amplifier input channel. There is no special priority as to which specific channel (i.e. left, right, center, etc.) is connected to which amplifier channel when all four channels are used individually. You need only remember what the channel is, so that the proper speaker may be connected to the correct output. Make certain that both bridging switches are in the "normal" position. The toggle switches should be pointing up for both inputs. Connect the wire running to each speaker to the appropriate output channel as shown on the speaker icons to the right or left of the speaker connection binding posts. (Figure 2A) The "+" or "positive" connection goes to the top binding post with the red barrel. The "-" or "negative" connection goes to the bottom binding post with the black barrel. TO PROCESSOR ^70r MO 'BRIDGED INPUT( P IXTLlrOTN UHN, ';' BRIDGED MODE, ,, p) ON CUT REMOTE (Th BRIDGED BRIDGED H 3 NPUT CH 4 INPUT (BRIDGED INPUT, - MOT USED IN BRIDGED MODE, BRIDGED CH 1 LTPUT CH CH 3 Back In Lit Note: Both Bridge/Normal switches shouldpoint Up to the "Normal" position. Figure 2A Four-Channel Operation with DualDrive Dipoles Three-Channel Operation: When one high-powered channel and two medium-powered channels are required, the three-channel mode is used. Using high quality interconnect cables, link the output of your processor or preamplifier for the moderate powered channels (left/right front or surround channels) to the input connectors marked "Channel One" and "Channel Two". Be certain that the bridging switch on the left side of the rear panel, above the inputs for Channel One and Channel Two, is in the "Normal" position with the toggle switch pointing up. Connect the output from your processor or preamp which is to be connected to the higher powered amplification channel (center or subwoofer channels) to the input connector marked "Channel Three" on the rear of the Citation 7.1. The input connection for "Channel Four" is not used in this configuration. (Figure 2B) 14