Harman Kardon DP 1US Owners Manual - Page 6
Installing Components - installation
View all Harman Kardon DP 1US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installing Components Installing the Electronics Enclosure At the selected site, install the Electronics Enclosure. Use either the enclosed cable ties or mounting screws, as shown below. b. Select another viewing angle position (middle or top). Reassemble the parts in reverse order and tighten the recessed hex screw. 3mm Hex Key Display Base Display Assembly Installing the Text Display 1. Temporarily place the Text Display at the proposed site and check the default viewing angle while adjusting the pivot arm. If it meets your needs, then skip to step 2. Otherwise, change the viewing angle as follows: a. Using the 3mm hex key, loosen the recessed hex screw (inside the display base) until the pivot arm is free from the display assembly. The hex screw will remain captive. 2. At the base, using the 1.5mm hex key, loosen (but do not remove) the hex setscrew. 3. To install the Text Display with adhesive tape, perform the following steps or skip to step 4: a. Insert the mounting plate, rotate it 180°, and tighten the hex setscrew as shown below. Recessed Hex Screw 6 INSTALLATION Hex Setscrew Mounting Plate Adhesive Pad