Harman Kardon FESTIVAL 2 Owners Manual - Page 15

Selecting monophonic or FM stereo broadcasts SELECTING MONOPHONIC OR FM STEREO BROADCASTS Under normal use for all F'M broadcasts, the function Selector Switch should be placed in the AUTO FM position. Your system is equipped with a stereo sensing circuit which can automatically determine if your unit is receiving monophonic or stereophonic broadcasts, and then automatically adjust the mode of operation. If the station is transmitting stereo, your system will automatically switch in the multiplex section and you will hear the broadcast in full stereo. Should the station conclude broadcasting in stereo, your system will automatically switch back to monophonic reception. Should you receive a weak signal whose quality has been degraded by noise or poor signal conditions, and you wish to listen to this stereo broadcast, monophonically, place the function selector switch in the MONO FM position. O AUX TAPE OUT ® ® R L 0 HARMAN KARDON INCORPORATED PLAINVIEW,N.Y. MODEL FESTIVAL 2 MADE IN U.S.A. 0 PREAMP 0 RI L&TT AMP G QUADRAPHONIC SERIAL NO. HIGH VO SERVIC MOVED GND QUADRAPHONIC RECEPTACLES These receptacles are intended for use with any accessory equipment designed to be installed between a preamplifier and power amplifier. This includes such equipment as electronic audio equalizers, reverberation units, and a new quadraphonic processor offered by Harman-Kardon. In order to make use of this facility, simply disconnect the two patch cords connected to these receptacles and follow the instructions supplied with the accessory equipment. NOTE: When no accessory equipment is being used, the two patch cords MUST be installed in order to use your Music System.