Harman Kardon FESTIVAL 2 Owners Manual - Page 22

HOW TO RECORD WITH MICROPHONES -10 0 +3 CEO A HARMAN-KARDON microphone may be purchased as an added RECORD LEVEL accessory for use with your music system, but if you prefer using another microphone for recording purposes, it MUST BE A LOW OFF(:) IMPEDANCE TYPE (BETWEEN 500 and 1000. OHMS). 1. Place the function selector MONO STEREO switch of your Music System MICROPHONE to AUX . LEFT RIGHT *T- 2. Set the VOLUME CONTROL MOM to minimum. 3. If you plan to make a mono- MONO phonic recording, insert one microphone into the MONO LEFT input receptacle. 4. If you plan to make a stereo- phonic recording, insert one microphone into each of the microphone input receptacles. 5. Refer now to the RECORDING PROCEDURE and follow steps ERASING TAPES #3 through #10. 6. As you record, your voice could vary in amplitude and direction and it may be necessary for you to carefully monitor the While in the process of making a recording, any previously recorded information on the tape will automatically be erased. It follows, therefore, that no procedure is required to erase a tape prior to re-use. proper record level prior to In the event you want to eliminate a portion of a tape or even making a recording. To ac- the entire tape, the following procedure should be followed: complish this, follow step #11 1. Place the FUNCTION SELECTOR switch to the "AUX" position. of the RECORD PROCEDURE. 2. Rotate the "RECORD LEVEL" control to its minimum position 7. When the controls are properly (full counterclockwise). set and you are ready to re- 3. Depress both the "RECORD" and the "PLAY/RECORD" buttons cord with the microphones, de- simultaneously. This will cause the tape to pass across the erase press the PAUSE button and head and any material previously recorded will be erased begin recording. from it.