Harman Kardon HK200 Owners Manual - Page 12

Your receiver is protected by a 2 % amp-3AG fuse. In the event of fuse failure replace ONLY with the same type used. Replacing with a fuse of a higher rating will not protect the instrument and may result in severe damage. HUM AND NOISE In any high fidelity installation, hum may be caused by the interconnection of a record player, tuner and amplifier, as a result o f the cables and different grounds. If hum i s experienced with your receiver, disconnect everything but the speakers from the receiver. If hum persists, reverse the AC line cord. Plug in the record player and i f hum appears, reverse the record player power plug and connect a single lead from the record player chassis to the ground post on the rear of the receiver chassis. Connect your other devices in this manner. CAUTION: Hum may be also induced by defective connecting cables or by running these cables too close to a strong AC field. SERVICE I f this instrument should not perform properly during the first two (2) years after date of purchase, contact the factory for instructions. The factory has many authorized warranty service stations in the United States, and for the station nearest you, please write our Customer Service Department, Harman Kardon, Inc. Plainview, Long Island, New York. Be sure to include the model and serial number of the unit. A brief description of your other components i s often of help in answering your questions. DO NOT return this instrument to Harman Kardon without first receiving authorization. CUSTOM INSTALLATION 1 . Locate and drill (4) 3 / 1 6 " diameter holes on mounting shelf. 2. Position and cut out front panel opening. (Bottom of opening should be flush with top of mounting shelf.) 3 . Remove (4) rubber feet from unit. (Rubber feet and screws are no longer used for cabinet installation). 4. Install unit from front through panel cutout opening. 5. Fasten unit to mounting shelf. If 1/2" thick mounting shelf was used fasten with (4) #6 x 3h" long self-tapping screws and washers. If 3hJJshelf was used fasten with (4) # 6 x 1" long self-tapping screws and washers. MOUNTING SHELF I I 14- TOTAL 32 12 MIN c TOP VlEW J FRONT PANEL ESCUTCHEON I I i' I PANEL CUTOUT FOR CUSTOM MOUNTING. 331 MAX FRONT V I E W L IMIN 2