Harman Kardon HK200 Owners Manual - Page 4

Hot Side Of Each Of These Speakers. If Two Of The Speakers Are

Get Harman Kardon HK200 PDF manuals and user guides View all Harman Kardon HK200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

CONNECTING THE SPEAKERS FOR STEREO OPERATION (2 SYSTEMS) 1. Connect all 4 speakers for your two system operation as shown in Diagram B. 2. You may now select either system 1, system 1 and 2 or system 2 by the use of the speaker selector switches located on the left side of the front panel of your Nocturne receiver. NOTE: WHEN ALL THE SPEAKERS USED I N YOUR 2 SYSTEM CONNECTION ARE 4 OHMS, CONNECT A 2 OHM, 10 WATT RESISTOR IN SERIES WlTH THE HOT SIDE OF EACH OF THESE SPEAKERS. (IF TWO OF THE SPEAKERS ARE 4 OHMS AND 2 OF THE SPEAKERS ARE ANY HIGHER IMPEDANCE THlS PRECAUTION IS NOT NECESSARY.) SYSTEM I CONNECT SPEAKERS WlTH CARE -AVOID ACCl DENTAL SHORTS CONNECTING THE SPEAKERS FOR MONOPHONIC OPERATION (1 SYSTEM) I f your receiver is to be used monophonically and stereo is t o be added at a later date, it is essential that both speaker output terminals are terminated into a proper load to prevent damage to the output stage o f he receiver. Refer to Diagram C for proper installation of the loading resistor. At no time should the output terminals be paralleled for monophonic operation l SYSTEM I CONNECT SPEAKER WlTH CARE- AVOID ACCIDENTAL SHORTS DIAGRAM B SYSTEM 2 SYSTEM I DIAGRAM C THlS IS THE ONLY CORRECT METHOD FOR CONNECTING ONE SPEAKER TO YOUR RECEIVER a

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
CONNECTING THE SPEAKERS FOR STEREO OPERATION
(2
SYSTEMS)
1.
Connect all
4
speakers for your two system operation as shown in
Diagram
B.
2.
You may now select either system
1,
system
1
and
2
or system
2
by the
use of the speaker selector switches located on the left side of the front panel
of your Nocturne receiver.
NOTE: WHEN ALL THE SPEAKERS USED I N YOUR
2
SYSTEM CONNECTION ARE
4
OHMS, CONNECT A
2
OHM,
10
WATT RESISTOR
IN
SERIES WlTH THE
HOT SIDE OF EACH OF THESE SPEAKERS. (IF TWO OF THE SPEAKERS ARE
4
OHMS AND
2
OF THE SPEAKERS ARE ANY HIGHER IMPEDANCE THlS PRE-
CAUTION IS NOT NECESSARY.)
SYSTEM I
CONNECT SPEAKERS
WlTH CARE -AVOID
ACCl DENTAL SHORTS
SYSTEM
2
DIAGRAM
B
CONNECTING THE SPEAKERS FOR MONOPHONIC OPERATION
(1
SYSTEM)
If your receiver is to be used monophonically and stereo is to be added at
a later date, it is essential that both speaker output terminals are terminated into
a proper load to prevent damage to the output stage of he receiver. Refer to
Diagram C for proper installation of the loading resistor.
At no time should the output terminals be paralleled for monophonic
operation
l
SYSTEM
I
CONNECT SPEAKER
WlTH CARE- AVOID
ACCIDENTAL SHORTS
SYSTEM
I
DIAGRAM C
THlS IS THE ONLY CORRECT METHOD FOR
CONNECTING ONE SPEAKER TO YOUR RECEIVER
a