Harman Kardon HK3500 Owners Manual - Page 7
connecting, speakers, their, impedance, switch, speakers, regardless, impedance, change, reset,
View all Harman Kardon HK3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
11 SPEAKER SYSTEM FT Et 0 SPEAKER SYSTEM 2 SPEAKER OPERATING MODE 11,11, • 0 0 O O O 0 2955A 2SSW SWITCHED UNSWITCHED MAX 180W.1.5.0 MAX 180W1.SA AC 1205/60H7 IMPORTANT: When connecting two pairs of speakers, determine the impedance of each pair by looking on the back of the speakers, or in your owner's manual, or by contacting your dealer or manufacturer. Then refer to the following chart to see if both sets may be played simultaneously. If impedance of the two pairs is: 851/8O 852/652 8O/452 60/652 6Q/45-2 4O/45 Can both pairs be played simultaneously? YES NO NO NO NO NO WARNING: Do not play both sets of speakers simultaneously except as recommended above. Receiver may overheat. Setting the Speaker Operating Mode 1. Determine the impedance of your speakers by looking on the back of the speakers or in your owner's manual, or by contacting your dealer or the manufacturer. 2. Be sure Power switch is turned off. 3. Locate the switch marked "4Q/8O" on the back of the receiver. ■ If you are connecting only one set of speakers, and their impedance is 8Q, set the switch to 852. ■ If your speakers impedance is less than 852, or if you are connecting two sets of speakers, regardless of their impedance, set the switch to 4O. NOTE: If you change or add speakers, be sure to reset the switch accordingly. 6