Hayward Aqua Rite AQ-RT-PRO prior to Oct 08 - Page 11

The Aqua Rite Pro periodically reverses the polarity of the voltage applied to the cell in order to automatically clean off any calcium deposits that may have built up on the cell. It is important that you check the chlorinator operation in both polarities. To do this, press either the "+" or "-" buttons and the chlorinator will turn off, wait for 15 seconds and then turn on in the opposite polarity. Salt Level 3200 PPM No function Move to previous/next menu item This is the average "Salt Level" in the pool. This value is calculated over time and minimizes the effects of spikes or dips that may naturally occur. Instant Salt 3200 PPM (+=save) Press to load the "Instant Salt" into the averaged salt display Move to previous/next menu item The "Instant Salt" is calculated based on the voltage, current (amps), and water temperature at the cell at that instant. There are a number of reasons why instant and average salt readings may differ. Some of these include salt having just been added to the pool and not yet thoroughly mixed, calcium buildup on the cell, and cell aging. Press the "+" button to enter the instant salt value into the average salt level. The average salt level will use this new value for its calculations. Flow Switch Flow No function Move to previous/next menu item The current status of the flow switch is displayed. There is a short delay when transitioning from flow to no-flow and a longer delay on the transition from no-flow to flow. The delay time is displayed. Main Software Revision 2.40 No function Move to previous/next menu item Display Software Revision 3.10 No function Move to previous/next menu item Chemistry Sense Software r1.00 No function Move to previous/next menu item Available displays depend on configuration. These displays show the software revisions of various components. Inspect Cell hold + to reset Press to reset Move to previous/next menu item For optimum operation, you will need to inspect the Aqua Rite Pro chlorinator cell approximately every 3 months and clean the cell if necessary. The Aqua Rite Pro will automatically remind you and display "Inspect Cell, hold + to reset" as part of the rotating Information Menu. Clean the cell and then press the "+" button during the "Inspect Cell" display to reset the timer. 8