Hayward AquaBug 500 - Page 7

Above-Ground Automatic Pool Cleaner Troubleshooting Problem Slowino torward movement Cleaners movement is fast and ensue Cause Solution Lack oil-improper water flow through cleaner CleanIn-Line LeafCanister Clean Hair and Lint Pot Clean Filter System Partial blockage of cleaner throat Clear blockage Worn shoes Worn wings Remove V5I2A Replace shoec Replace wings Turn off filter and turn cleaner upside down. Insert a small screwdriver in the notch at the rear of the opening. Using a prying motion. remove the throat. Cleaner sticks at ladder or wall Improper vacuum Worn shoes Hose too short Stuck on ladder Steering failure It may be necessary to purchase an AXV096P, "In-Line" vacuum gauge from your Hayward dealer to verify performance of your system Replace shoes Add additional hose per installation instructions Remove ladder or install a Hayward AXW100 Ladder Bumper Check and clean rear screen Check to see if cone gear rotates smoothly in both directions ir the cleaner appears to be stuck or "hung up" at the wall, ladder, or other obstruction, or anywhere else in the pool, and does not return to normal operation within a minute or so, turn the filter system OFF. Remove the cleaner from your pool. Check for blockages or any other obvious problems. (Ilea the Bumper Ring for free rotation. Check filter system for water flow and re-install the cleaner. If the cleaner is getting stuck, contact your Hayward dealer or Hayward at l -800-227-I477. Under no conditions should the cleaner remain in the pool connected to the filter system if the problem of getting stuck or "hung up" is not corrected. To better serve you, please have the following information available if you call Hayward's Technical Service Department at 1400-227-1477 (U.S.A. only) or 1-707-422-5400: I ) The purchase date of your cleaner. 2) The serial number (located on the bottom) of your cleaner.