Hayward C100S SwimClear Single Element Manual - Page 6

CLEANING CARTRIDGE The cartridge filter element can be cleaned by washing inside and out with a garden hose. (The cartridge is easier to clean when dry.) After hosing the cartridge, for best results, allow cartridge to dry and carefully brush pleated surface areas to remove fine particles. Do not pressure wash, as it can damage the filter element. To remove materials such as suntan and body oils from the cartridge pleats, soak the element in a solution of filter element cleaner (various brands available at pool dealer). Follow manufacturer's directions for use and allow an hour for soaking. Hose thoroughly before reinstalling in filter. CAUTION: Be sure to use a plastic container and take extreme care when handling cleaning agents as they can be harmful to eyes, skin and clothing. After cleaning flush with water. NON-CHLORINE POOLS Cartridges used in pools or spas that use Baquacil® Sanitizer or other similar non-chlorine based products must be cleaned more frequently than when used in pools that utilize a chlorine system. Consult manufacturer's instructions for frequency, instructions, and chemicals required for cleaning elements in these types of systems. Baquacil® is not compatible with chlorine, bromine, any copper based chemical or non-chlorine shock. A spare cartridge filter element is an excellent investment. It provides convenience and ensures that your filter will always be ready to operate at peak efficiency. VACUUMING Vacuuming can be performed directly into the filter whenever needed. Clean cartridge after vacuuming, if required. WINTERIZING (Filter) In areas where sub-freezing temperatures can be expected, the filter should be drained and/or removed from it's operating location and stored indoors. Remove and clean cartridge. Reinstall cartridge in filter tank. Fully tighten lock ring when storing. SERVICE AND REPAIRS Consult your local authorized Hayward dealer or service center. No returns may be made directly to the factory without the expressed written authorization of Hayward Pool Products. EFFECTIVE DESIGN FLOW RATE DESIGN FLOW RATE MODEL FILTRATION AREA RESIDENTIAL PUBLIC FT2 M2 GPM LPM GPM LPM C100S 100 10.8 100 410 37.5 150 C150S 150 13.9 120 454 56 212 C200S 200 18.6 120 454 75 284 MAXIMUM WORKING PRESSURE FOR ALL MODELS 50 PSI (3.45 BAR) Head Loss (Feet of Head) 4.50 4.00 3.50 3.00 2.50 2.00 1.50 1.00 0.50 0.00 0 SwimClear Head Loss C200S 20 40 60 80 100 120 140 Flow in GPM USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 6