Hayward HeatPro Heat Pro Installation - Page 14

Page 14 of 20 HEATPRO HEAT PUMP HP13023770 Rev: E Installation in Combination with Solar or Gas Heaters If you are installing a heat pump in combination with any other type of heating device, please call the HAYWARD service department at (908) 355-7995. We will advise you of installation practices that will help keep your warranty valid. Other pool heaters, such as gas-fired or solar-powered devices must be installed in a parallel circuit and operated independently (only one at a time) for your warranty to stay valid. NOTICE - Because of the intense heat that can be generated by gas and solar units, isolating it with a shut-off valve and a check valve when gas or solar heater is in operation protects the heat pump. Failure to follow the instructions may result in property damage. Notes: 1. Isolate the heat pump from hot water flow of heating devices such as gas or solar heater. 2. Install bypass loop for Hayward heat pump unit. Electrical Specifications WARNING - RISK OF ELECTRICAL SHOCK OR ELECTROCUTION Failure to follow the instructions may result in permanent injury or death. All electrical wiring MUST be in conformance with all applicable local codes, regulations and the National Electric Code (NEC). Ground and bond the heat pump before connecting to electrical power supply. Failure to bond the heat pump can cause serious or fatal electrical shock hazard. DO NOT ground to a gas supply line. To avoid dangerous or fatal electrical shock, turn OFF power to the heat pump before working on electrical connections. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com