Hayward Navigator Pro Pool Vac Classic - Page 14

Navigator Pro MAINTENANCE TIPS 5. Navigator Pro Skirt/Mid Section Replacement: Replacement of the Navigator Pro Skirt/Mid Section is not recommended as DIY repair. There is strong possibility that the replacement could cause propulsion system issues. It is strongly suggested that you bring your Navigator Pro to a HAYWARD dealer for replacement. 6 5 4 3 2 Tools required - #2 Phillips screwdriver 1/8" flat screwdriver Preliminary steps - Turn off pool pump Remove Navigator Pro from pool Disconnect suction hose from cleaner Change out steps - 2 1 1 1. Insert the 1/8" flat screwdriver into each slot in the Middle Body and pry each Handle snap off the 3 Middle Body. 2. Using the phillips screwdriver, remove and retain the four screws holding the Middle Body onto the Main Drive Assembly. 4 3. Lift the old Skirt/Middle Body assembly off the Main Drive Assembly. 4. Set the new Skirt/Middle Body assembly onto the Main Drive Assy. 5. Reattach the Skirt/Middle Body assembly by screwing in the four screws previously removed. 6. Engage the Handle rear hooks under the top rear retainers in the Middle Body. Rotate the Handle down in front. Insure the snaps and the side tabs are aligned to the Middle Body slots and push the Handle down until it snaps into the Middle Body. 6 5 4 3 2 3 2 12