Hayward OnCommand Model: ALL MODELS Operation - Page 12
Timers Menu - on command pool controls
View all Hayward OnCommand manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Teach Wireless + to start Press and hold wireless button Teach Wireless Successful Teach Wireless NOT Successful Teach Wireless Base NOT Found Push to start process Move to previous/next menu item Press any button on wireless remote Move to previous/next menu item Move to previous/next menu item Move to previous/next menu item Move to previous/next menu item This menu will only appear if a wireless base station is connected to the OnCommand. Perform this procedure each time a wireless remote control is added to the OnCommand system. During this procedure the wireless remote "learns" and remembers the ID code for the wireless base station connected to this particular OnCommand unit and will reject messages with any other ID codes. If "Base NOT found" is displayed, then the OnCommand can not communicate with the transmitter/ receiver base station attached to the main unit. If "NOT Successful" is displayed, then the base station did not receive a signal from the remote control. This may be due to the distance between the Base Receiver and the remote device being too great or may be due to interference caused by other RF equipment operating in the neighborhood. Try changing the channel and then repeat the "Teach Wireless" command. Wireless Channel: 1 Confirm Change: + to proceed Reteach all wireless units Change the desired wireless channel (1 - 5) If channel is changed, move to confirmation menu If channel is not changed, move to previous/next menu item Push to confirm the channel change Move to previous/next menu item Move to previous (Teach Wireless) menu This setting changes the channel to be used by the wireless base station and remote(s). If the channel is changed and confirmed, all of the wireless remotes will have to be retaught. This menu will only appear if a wireless base station is connected to the OnCommand. Timers Menu The Timers Menu allows you to set all timeclock and countdown timers which control the automatic operation of your pool/spa system. The OnCommand has 4 timeclocks available for each function. Each timeclock has a single on/off program per day. All of the timeclocks are programmed in the Configuration Menu either as "all days" or "weekends/weekdays". If "weekends/weekdays" are selected, the start and stop times will need to be programmed separately for both weekdays and weekends, even if the same times will be used. All times are adjusted in 15 minute increments (9:00A, 9:15A, 9:30A, etc.). If you program the start time equal to the stop time (ex. "10:00A to 10:00A"), the function will be disabled and the display will show "Off". If, at a later time, you wish to re-activate the timeclock, simply press either the "+" or "-" buttons to go back to a normal timeclock programming display. Two speed or variable speed pumps: Two timeclocks are required to program the run time for dual or variable speed pumps. One timer is used for high speed, the other timer for low speed. The Countdown timer is programmed in increments of 5 minutes from "Manual On/Off" (0 minutes) to a maximum of "21:00" (21 hours). When "Manual On/Off" is displayed, the countdown timer is disabled and the output will be manually controlled. When a countdown timer is equal or greater than "0:05", pressing the appropriate output button will turn the output on and start the timer. Pressing the button again will turn the output off or, when the programmed time has elapsed, the output will automatically turn off. 9