Hayward OnCommand Model: ALL MODELS Operation - Page 25

Remote Menus Enabled Toggle between Enabled (default) and Disabled Remote Menus Move to previous/next configuration menu This feature will prevent unauthorized access to the Settings, Timers, and Configuration menus from any of the OnCommand's remote display/keypads. When disabled, the remote display/keypads will only show the default menu and allow on/off control via the pushbuttons. Note that the function of the OnCommand's built-in display/keypad is unchanged by this selection. Once disabled, the only way to enable "Remote Menus" is to use the local display/keypad. All Timeclocks 7-day Toggle between 7-day (default) and Weekend/Weekday time options Move to previous/next configuration menu This selection affects ALL of the timeclock logic in the OnCommand. If "7-day" is selected, each timeclock will have one set of turn-on/turn-off settings that operate every day of the week. If "Weekend/ Weekdays" option is selected then the user can enter one set of turn-on/turn-off times for the weekend (fixed as Saturday/Sunday) and another set of turn-on/turn-off times for weekdays (Monday through Friday). Time Format 12 hour AM/PM Units ºF and PPM Toggle between 12 hour AM/PM (default) and 24 hour time format options Move to previous/next configuration menu Toggle between ºF and PPM (default) and ºC and g/L (Metric) options Move to previous/next configuration menu Reset Config. to Default Press + Initiate reset of all configuration parameters Move to previous/next configuration menu (config. not reset) Are you sure? + to proceed Reset all configuration parameters Move to previous/next menu (config. not reset) Config. reset Confirmed Move to previous/next configuration menu Use this function to erase all previous system configuration and reset all configuration parameters back to the factory default values. This function is NOT reversible--be careful. Quick "How To" Guide Operate the Spa-Manually 1. Press the "Pool/Spa" button to go to "spa-only" operation (right LED illuminated). In some cases, this may take more than one press of the button. 2. If the filter pump is not already on, press the "FILTER" button to turn it on. 3. If the spa is below the desired temperature, the heater will turn on automatically when the filter pump is on and the valves are in the spa-only position. If you have not already set the desired temperature for the spa, see "Set Heater Temperature" below. 4. If the spa has a separate jet pump and or blower, determine if the jet pump/blower is controlled by Aux1 or Aux2 (it should be marked on the label inside the door). Then press the appropriate button to turn on the jets/blower. Operate the Spa-Automatically 1. Press the "MENU" button repeatedly until "Timers Menu" is displayed. 2. Press the ">" button repeatedly until the "Spa-all" or "Spa-wkend" is displayed. 3. Use the "+" and "-" buttons to set the desired start time, then press ">" to switch to the off time. Use the "+" and "-" buttons to adjust the off time. If you are setting the "weekend" timeclock, press ">" to go to the "weekday" settings. 22