Hayward Salt & Swim ABG 23 000 gallons outlet plug has straight blades Salt &a - Page 3

Page 3 highlights

Introduction Salt & SwimTM 3C is an automatic chlorine generation system for pool sanitization. It is designed for inground swimming pools up to 30,000 gallons only. Salt & Swim 3C is NOT to be used with above ground pools or with inground pools greater than 30,000 gallons. Salt & Swim 3C requires a low concentration of salt (sodium chloride) in the pool water. It automatically sanitizes your pool by converting the salt into free chlorine which kills bacteria and algae in the water. Chlorine will revert back to sodium chloride after killing bacteria. These reactions will continuously recycle virtually eliminating the need to add sanitizing chemicals to your pool. Salt & Swim 3C can handle the purification needs of most residential swimming pools up to 30,000 gallons (114,000 liters). This unique low cost chlorine generator uses a replaceable electrolytic Cell (SAS-CELL) that is designed to produce 200lbs of 100% available chlorine over its lifetime. Note that the actual amount of chlorination required to properly sanitize a pool varies due to bather load, rainfall, temperature, and the pool's cleanliness. NOTE: Before installing this product as part of a saline water purification system in a pool or spa using natural stone for coping or for immediately adjacent patios/decking, a qualified stone installation specialist should be consulted regarding the appropriate type, installation, sealant (if any) and maintenance of stone used around a saline pool with electronic chlorine generator in your particular location and circumstances. NOTE: The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid regions where pool water is subject to excessive evaporation and is not commonly diluted with fresh water. Dry acid can cause a buildup of by-products that can damage your chlorinator Cell. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
Introduction
Salt & Swim
TM
3C is an automatic chlorine generation system for pool sanitization.
It is designed
for inground swimming pools up to 30,000 gallons only.
Salt & Swim 3C is NOT to be used
with above ground pools or with inground pools greater than 30,000 gallons.
Salt & Swim 3C requires a low concentration of salt (sodium chloride) in the pool water.
It auto-
matically sanitizes your pool by converting the salt into free chlorine which kills bacteria and algae
in the water.
Chlorine will revert back to sodium chloride after killing bacteria. These reactions
will continuously recycle virtually eliminating the need to add sanitizing chemicals to your pool.
Salt & Swim 3C can handle the purification needs of most residential swimming pools up to 30,000
gallons (114,000 liters).
This unique low cost chlorine generator uses a replaceable electrolytic
Cell (SAS-CELL) that is designed to produce 200lbs of 100% available chlorine over its lifetime.
Note that the actual amount of chlorination required to properly sanitize a pool varies due to bather
load, rainfall, temperature, and the pool's cleanliness.
NOTE: Before installing this product as part of a saline water purification system in a pool or
spa using natural stone for coping or for immediately adjacent patios/decking, a qualified stone
installation specialist should be consulted regarding the appropriate type, installation, sealant (if
any) and maintenance of stone used around a saline pool with electronic chlorine generator in
your particular location and circumstances.
NOTE: The use of dry acid (sodium bisulfate) to adjust pool pH is discouraged especially in arid
regions where pool water is subject to excessive evaporation and is not commonly diluted with
fresh water. Dry acid can cause a buildup of by-products that can damage your chlorinator Cell.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS