Hayward Sense and Dispense Model: AQL-CHEM - Page 7
Wiring the probes to the Probe Cell, Wiring the Probe Cell to the Aqua Rite Pro or Pro Logic, Pro - system
View all Hayward Sense and Dispense manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Wiring the probes to the Probe Cell Both probes must be wired to the communication box within the Probe Cell. The probe cables use typical BNC connectors that attach to the designated connectors on the communication box. Refer to the label on the communication box for the appropriate connections. Push the connectors in and turn clockwise until locked. After connecting, route the wires in a manner where they will not interfere with the door of the Probe Cell. Save BNC connector protective covers for future use. Wiring the Probe Cell to the Aqua Rite Pro or Pro Logic The Probe Cell is supplied with a 15' cable which connects to the circuit board of the Aqua Rite Pro or Pro Logic. Route the cable through an available knockout and make the proper connection as shown below. When side mounting the Probe Cell, route the cable through the access hole at the bottom of the mounting bracket BEFORE screwing the bracket in place. Route cable through access hole Aqua Rite Pro Route though knockout Pro Logic Route cable through access hole Route though knockout 6