Hayward SwimClear™ Models: C2030 C3030 C4030 C5030 C7030 - Page 6
Maintaining Your Filter - swimclear filter parts
View all Hayward SwimClear™ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
By recording the initial starting pressure (with clean filter elements) a determination can be made when the filter cartridge elements should be replaced rather than cleaned. After the filter elements have been cleaned and reinstalled if the starting pressure is higher than 6 PSI above the starting pressure with the new filter cartridge elements, the filter cartridge elements should be replaced the next time the gauge arrow reaches the red arrow. MAINTAINING YOUR FILTER WARNING This product should be installed and serviced only by a qualified pool professional. FILTER DISASSEMBLY INSTRUCTIONS 1. Turn off all system circulation pumps and all electric power on the equipment pad. Figure 4 2. Set all system valves in a position to prevent water flow to the filter. 3. The manual air relief valve must be placed in the OPEN position. (Fig 6) 4. Remove filter drain plug (Fig 4) and drain water from filter. 5. Using 3/4" wrenches or hex sockets, loosen and remove the clamp nut and the clamp bolt. (Fig 5) 6. Holding both ends of the filter clamp carefully spread the clamp ends. Remove the clamp by lifting over the upper filter body. Do not to drop the clamp during removal, because the clamp could be damaged. Do not strike the clamp with metal tools as they can damage the clamp. 7. Lift off upper filter body. Do not use the pressure gauge to lift the upper filter body. Figure 6 Figure 5 Clamp Bolt Clamp Nut REMOVING Manual Air Relief Shown in Open CARTRIDGES 1. Remove the top Manifold, which is exposed when the upper filter body is removed. (Fig 4) 2. Remove the filter cartridge elements by using slight rocking motion and lifting up. 3. Clean filter cartridge elements. CLEANING CARTRIDGES The Cartridge filter element can be cleaned by washing inside and outside with a garden hose. After hosing cartridge, for best results, carefully brush the pleated surface to remove fine particles. Do not pressure wash as it can damage the filter element. You may find some debris on the cartridge pleats, which may not have been removed with hosing. Page 6 of 12 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS SWIMCLEAR™ CARTRIDGE FILTER ISC2031 REV A