Hayward SwimClear™ Models: C2030 C3030 C4030 C5030 C7030 - Page 7

FILTER RE-ASSEMBLY INSTRUCTIONS WARNING RE-INSTALLING CARTRIDGES 1. Flush and drain any dirt or debris from the bottom of the lower filter body. 2. Flush any dirt or debris from the upper filter body and from around the manual air relief area. 3. Carefully replace the cartridges over the hubs on the bottom seal plate. 4. Place top manifold securely on top of cartridges, aligning the return pipe with the port in the manifold. CLEAN SEAL RING AND SEAL SURFACE 1. Remove filter tank seal. 2. With a clean cloth, wipe the lower filter body seal surface and clean seal of all dirt and debris. (Fig 4) Do not use a solvent. 3. With a clean cloth wipe the upper filter body seal surface. Figure 7 Notice: • Do not use any petroleum solvents to clean filter components. • Do not lubricate DEX2422Z2 seal. Clamp bolt WARNING This product should be installed and serviced only by a qualified pool professional. Rounded end of nut Figure 8 BODY AND CLAMP RE-ASSEMBLY 1. Place the metal reinforced seal on lower filter body. (Fig 4) Place upper filter body on metal reinforced seal and lower filter body in a position which allows all operation and safety labels to be clearly visible and the upper filter body to be centered on the lower filter body. Press Clamp Bolt Tighten clamp bolt and nut using a torque wrench to 150 inch-lbs. down firmly and evenly on the upper filter Figure 9 Clamp Nut body to seat the seal. (Fig 7) 2. Replace the filter clamp around the upper and lower filter bodies. Hold the clamp ends to position the clamp on the filter bodies with the clamp ends adjacent to the safety and operation labels on the filter bodies. (Fig 7) 3. Insert clamp bolt through the clamp ends and thread the clamp nut onto clamp bolt with rounded end of the nut (Fig 8) towards the ends of the clamp. 4. Never rely on hand tightening of clamp nut to clamp bolt. Using a 3/4" socket on a torque wrench, torque clamp nut to clamp bolt to 150 inch-lbs. (Fig 9) DO NOT HIT OR STRIKE CLAMP WITH HAMMER OR METAL TOOLS. 5. Follow Operation Instructions for "Starting the Pump and Filter System" (Page 5). VACUUMING POOL Vacuuming can be performed directly into the filter whenever needed. Clean cartridges after vacuuming, if required. Page 7 of 12 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS SWIMCLEAR™ CARTRIDGE FILTER ISC2031 REV A