Hayward TigerShark® All Models - Page 4

READ THESE IMPORTANT OPERATING TIPS BEFORE USING YOUR UNIT! Dear Hayward Robotic Cleaner Owner: Thank you for choosing Hayward. In order to achieve optimal performance, please read and follow these steps: 1. Cleaner filter cartridges should be thoroughly cleaned after each use or as often as needed to ensure cleaner's optimal performance. 2. Before using your cleaner and especially when opening the pool for the first time remove larger items from the pool that may diminish the cleaner's performance. Clean filter frequently when pool is excessively dirty. 3. Cleaner may periodically go to the wall but not necessarily climb to the vertical position. This is a normal part of the programmed cycle. 4. Cleaner may stop in the middle of the pool and reverse during cleaning cycle. This is a normal part of the programmed cycle. 5. DO NOT start cleaner out of the water. Power button should only be switched to "On" position when unit is fully submerged. The unit will automatically shut off, but it is best to put power switch in "OFF" position when unit completes cleaning. 6. Only plug into a GFCI (Ground Fault Circuit Interrupter) protected 110-120 volt AC outlet (220-240 volt for 240 volt models). 7. Place the cleaner power supply so that it is at a minimum distance of 10 feet from the pool edge. The length of the standard cleaner cable is 55 feet. Page 4 of 16 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS ROBOTIC POOL CLEANER ISRC10202 REV C