HealthRider H10x Bike English Manual - Page 10

8. Identify the Right Handlebar (48) and orient it as shown. 8 While a second person holds the Right Handlebar (48) near the Upright (3), tie the indicated wire tie to the Right Pulse Wire (42). Then, pull the other end of the wire tie upward out of the top of the Upright. Tip: Avoid pinching the wire. Slide the Right Handlebar (48) onto the Upright (3). Attach the Right Handlebar (48) with two M8 x 38mm Bolts (53) and two M8 Locknuts (37). Make sure that the Locknuts are in the hexagonal holes. Attach the Left Handlebar (47) in the same way. 47 28 3 Avoid pinching the wire Wire Tie 53 42 48 37 Hexagonal Holes 9. The Console (6) can use four D batteries (not included); alkaline batteries are recommended. 9 Do not use old and new batteries together or alkaline, standard, and rechargeable batter- ies together. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before insert- ing batteries. Otherwise, you may damage the console displays or other electronic components. Remove the screws and the battery covers, insert batteries into the battery compartments, and then reattach the battery covers. Make sure to orient the batteries as shown by the diagrams inside the battery compartments. To purchase an optional power adapter, call the telephone number on the front cover of this manual. To avoid damaging the console, use only a manufacturer-supplied power adapter. Plug one end of the power adapter into the receptacle inside the indicated battery compartment; route the power adapter through the notch in the battery cover. Then, plug the other end into an outlet installed in accordance with all local codes and ordinances. Battery Covers Screws Notch 6 Receptacle 10