HealthRider H10x Bike English Manual - Page 21

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the exercise bike regularly. Replace any worn parts immediately. To clean the exercise bike, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. CONSOLE TROUBLESHOOTING Most console problems are the result of low batteries. See assembly step 9 on page 10 for battery replacement instructions. Using a flat screwdriver, release the tabs along the bottom edge of the Top Shield (9) and slide the Top Shield upward. Locate the Reed Switch (21). Turn the Pulley (13) until a Pulley Magnet (16) is aligned with the Reed Switch. Loosen, but do not remove, the indicated M4 x 16mm Screw (40). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. 13 If the console does not display your heart rate when you use the handgrip heart rate monitor, see step 5 on page 16. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must remove the seat post, the post knob, and the top shield (see the instructions below). To remove the Seat Post (5), loosen the Post Knob (11) a few turns, pull the Post Knob outward, and remove the Seat Post. Then, using an adjustable wrench, remove the Post Knob. 16 40 21 Turn the Pulley (13) for a moment. If necessary, repeat the step above until the console displays correct feedback. When the reed switch is correctly adjusted, reattach the shield cover, the post knob, and the seat post. 11 9 5 21