HealthRider Hr2 Rider English Manual - Page 7
M8 x 40mm Button Bolts 39, two M8 Curved
View all HealthRider Hr2 Rider manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
7. Orient a Seat Handlebar (9) as shown. Attach the 7 Seat Handlebar to the Seat Carriage (3) with two M8 x 40mm Button Bolts (39), two M8 Curved Washers (60), and two M8 Nylon Locknuts (40). Repeat this step for the other Seat Handlebar (9). 8. Loosen the Seat Knob (29). Orient the Seat Carriage 8 (3) as shown and slide it onto the Seat Frame (2). Attach the Seat Carriage with an M6 x 10mm Screw (55) and an M6 Spring Washer (56). Then, slide the Seat Carriage forward or backward to the desired position and retighten the Seat Knob. 9 3 60 60 39 9 40 2 29 56 3 55 9. The Console (12) requires one "AAA" battery (not 9 included); an alkaline battery is recommended. Carefully pry the Console away from the Upper Console Shroud (13) as shown. Be careful not to dislodge the reed switch wire. Insert the battery into the holder on the back of the Console. Make sure that the battery is oriented as shown by the diagram on the back of the Console. Then, reinsert the Console into the Console Shroud. 12 Reed Switch Wire 13 10. Make sure that all parts are properly tightened. To protect the floor or carpet from damage, place a mat under the exerciser. 7