HP 2420dn HP LaserJet 2400 Series - Software Technical Reference (External) - Page 233
Wait Timeout, Minimum Font Size to Download as Outline, Installable Options, Automatic Configuration - printer driver download
UPC - 829160290010
View all HP 2420dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
to print indefinitely. The default setting is 0 seconds. You can use the spin box to change this value to a maximum of 32,767 seconds. Wait Timeout This control specifies how long the product waits to get more postscript information from the computer. After the specified time passes, the product stops trying to print the document and prints an error message. If you are trying to print a very complicated document, you might want to increase this value. If you specify 0 seconds, the product waits indefinitely. The default setting is 300 seconds. You can use the spin box to change this value to a maximum of 32,767 seconds. Minimum Font Size to Download as Outline This control specifies the minimum font size (in pixels) for which the driver downloads TrueType fonts as outline (Type 1) fonts. A font smaller than the minimum setting is downloaded as a bitmap (Type 3) font. Use this option to fine-tune the Automatic setting for the TrueType Font Download option on the Advanced tab in Document Defaults. The default setting is 100 pixels. You can use the spin box to change this value to a maximum of 32,767 pixels. Maximum Font Size to Download as Outline This control specifies the maximum font size (in pixels) for which the driver will download TrueType fonts as bitmap (Type 3) fonts. A font larger than the maximum setting will be downloaded as an outline (Type 1) font. Use this option to fine-tune the Automatic setting or override the Send TrueType as Bitmap setting for the TrueType Font Download option on the Advanced tab in Document Defaults. The default setting is 600 pixels. You can use the spin box to change this value to a maximum of 32,767 pixels. Installable Options This section provides information to configure the printing options that you can install for the HP LaserJet 2410, 2420, and 2430 printers. The following controls are available: ■ Automatic Configuration ■ Tray 3 ■ Duplex Unit (for 2-Sided Printing) ■ Allow Manual Duplexing ■ Printer Memory ■ Job Storage ■ Mopier Mode ■ Postscript Passthrough (PS Emulation Unidriver only) Automatic Configuration Use the Device Settings tab to tell the driver about the hardware configuration of the product. If bidirectional communication is enabled in a supported environment, set up this tab by selecting the Update Now option under Automatic Configuration. The default setting is Off. After an automatic configuration, the setting returns to Off after the changes are made. HP unidrivers HP PCL 6, HP PCL 5e, and PS emulation unidriver features 217