HP 3150 HP LaserJet 3150 Product - (English Australia) Getting Started Guide - Page 44

Option B: Connecting to a network To connect the product to the network using an HP JetDirect print server, you need to do the following. a Purchase and install a supported HP JetDirect print server or check that the one you have is supported. (See page 13 for a list of supported print servers. See the documentation for the print server to install it.) b Test the hardware installation by printing a configuration page for the HP JetDirect print server. To do this, press Test on the print server. (If the page does not print, use ASCII as the printer language. See the documentation for the print server for further instructions.) c Check the model or firmware revision number, which is located in the first section of the configuration page you just printed. • If you have a 170X print server and the model number is not J3258B, you must get a new print server. • If you have a 300X or 500X print server and the firmware revision number is not H.08.00 or J.08.00 or higher, you must upgrade firmware before proceeding. (See "Upgrading firmware" below.) d Connect the HP LaserJet 3150 product to the print server. (See the documentation for the print server.) e Important! Unplug the power cord for the HP LaserJet 3150 product and replug it in. Otherwise, the product does not detect that it is on a network and will not work correctly. f Install the JetSuite™ Pro software for Hewlett-Packard on all computers that want to use it. (See "Preparing for software installation" on page 43.) 8SJUDGLQJILUPZDUH If you have a 300X or 500X print server and the firmware revision is not H.08.00 or J.08.00 or higher, you can download a firmware upgrade from the HP website at http://www.hp.com/ support/net_printing. Or, see the documentation that came with the HP JetDirect print server. 42 2 Finishing the installation EN