HP 600N HP JetDirect 600N Print Server Hardware Installation Guide - 5969-6858 - Page 23
For HP J3113A 10/100Base-TX cards, For LocalTalk-Only Customers, Installing the Print Server 2-9
UPC - 088698541357
View all HP 600N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Figure 2-3 Example of HP JetDirect Configuration Page I/O CARD READY Installing the 2 Print Server 3. If I/O CARD READY appears, the card has been installed successfully. Proceed to "Step 6. Configure the Card for Network Operation." 4. If I/O CARD READY does not appear, check that you have: I Installed the card correctly and properly connected the card to the network I Verified that the network is operating properly I Turned the printer off and then on again Note For HP J3113A 10/100Base-TX cards: See appendix A in this guide for special troubleshooting information. For LocalTalk-Only Customers: If you are not connected to an Ethernet network, "I/O CARD NOT READY" and "LAN ERROR - EXTERNAL LOOPBACK" messages may appear. These messages should stop appearing after three minutes. To eliminate the messages, attach an Ethernet loopback connector to one of the Ethernet ports. Installing the Print Server 2-9